Our window clings can be used indoors and outdoors. If you're placing it indoors, make sure that the front of the decal (right side facing) is being placed directly to the window. This ensures that your window cling can be read from outside. If you're placing it outdoors, then place the back of the decal against the window.
No matter which side of the window cling you intend to use, follow these 5 steps for easy application:
-
Clean - Clean the application surface with soap and water, then wipe dry ensuring there's no residue or lint left behind.
-
Wet - Wet the area again with a bit of soap and water.
-
Remove - Remove the window cling backing.
-
Place - Place the decal on the designated area by pressing down on one edge with your fingers. Slowly work towards the other edges, ensuring no bubbles form.
-
Smooth out - Gently smooth out any bubbles using your fingers or the provided squeegee (held at an angle) starting from the center and towards the edges.
TIPS:
-
After cleaning the application surface, it must be smooth and as close to room temperature as possible in order for the decal to cling properly.
-
You may use a spray bottle or damp towel to wet the surface again before application. Make sure it's not too wet as this will cause lots of bubbles to form.
-
While it's normal to have small bubbles, you can smooth these out with your finger.
-
When placing the window cling, you may need to lift it up a few times in order to get smooth application.